Measure macro with dual inch/mm units

[ERT]

Hi all,

Does anyone have a macro that imitates the MEASURE command but reports in both inch and mm at the same time?

This would be quite handy as we are often dealing in mixed unit assemblies.

The only previous reference I found was: thread559-27994
which is several years old.

Regards,

ERT
SW2006 SP3.4

 

[SBaugh]

From a SW standpoint - That would be an ER (Enhancement Request).... Otherwise you use the measurement tool and flip between the 2 like I am sure you are doing now.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376