material properties of concrete 1

[monchie]

Does ETABS has automatic properties for C30, C35, C40 concrete? I am having a hard time filling the material properties dialog box in etabs if I want to change to,ie, C35. Is there any reference that I can look up to in knowing different properties(I've tried to search on the internet but it doesnt relate to ETABS dialog box for properties).

 

[slickdeals]

No, you will have to define this manually. I have copy pasted the information for you from the ETABS model.
Units are KN,mm

MATERIAL "CM20" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 22.36 U 0.2 A 9.89999989542412E-06
MATERIAL "CM20" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.02 FYS 0.5
MATERIAL "CM25" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 25 U 0.2 A 9.89999989542412E-06
MATERIAL "CM25" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.025 FYS 0.5
MATERIAL "CM30" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 27.386 U 0.2 A 9.89999989542412E-06
MATERIAL "CM30" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.03 FYS 0.5
MATERIAL "CM35" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 29.58 U 0.2 A 9.89999989542412E-06
MATERIAL "CM35" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.035 FYS 0.5
MATERIAL "CM40" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 31.623 U 0.2 A 9.89999989542412E-06
MATERIAL "CM40" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.04 FYS 0.5
MATERIAL "CM45" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 33.541 U 0.2 A 9.89999989542412E-06
MATERIAL "CM45" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.045 FYS 0.5
MATERIAL "CM50" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 35.355 U 0.2 A 9.89999989542412E-06
MATERIAL "CM50" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.05 FYS 0.5
MATERIAL "CM60" M 2.402E-12 W 2.356E-08 TYPE "ISOTROPIC" E 38.729 U 0.2 A 9.89999989542412E-06
MATERIAL "CM60" DESIGNTYPE "CONCRETE" FY 0.5 FC 0.06 FYS 0.5