botnsnow
Electrical
- Jun 8, 2007
- 14
Morning chaps. To keep it short and sweet I had to rollback a user that had escaped us before from SW2006 SP5.1 to 4.1. However, I was told after the fact that the assemblies he had been editing had errors on all the mates when opened on a 4.1 machine. Now that this user is on 4.1 when he opens his assemblies they show up with a variety of mate errors but not all. I believe most if not all the errors are relating to mates with floating points and I have told him to recreate the mates and see if the error goes away.
Was there a SP change made that might be causing these errors?
Was there a SP change made that might be causing these errors?
