Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mate Curve to a Point

Thread starter yanceman
Start date Dec 28, 2006

Status: Not open for further replies.

Dec 28, 2006

yanceman

Mechanical

Hello all,

The "What's New" in SW2007 says that it is possible to mate a curve to a point. Has anyone tried this? The illustration shows a point on a cube and a helix, but Solidworks will not accept the helix in my model, only the point of the other part.

Yanceman
SW2007 SP2.0