Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Manufacruring Question

Status
Not open for further replies.

EngMfg1

Aerospace
Joined
Dec 9, 2004
Messages
40
Location
US
Does any one know of a way to save the cutters center line data as geometry on the screen?
 
In what program?

Fill what's empty. Empty what's full. And scratch where it itches.
 
You should search through and find the proper forum regarding the software you are using.

[green]"I think there is a world market for maybe five computers."[/green]
Thomas Watson, chairman of IBM, 1943.
Have you read faq731-376 to make the best use of Eng-Tips Forums?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top