Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Making up different weights of BTC thread connections

Status
Not open for further replies.
JKingR

JKingR

Petroleum
Joined
Apr 28, 2022
Messages
1
Location
US
Good day. Just want a thread expert to verify whether or not I can make up 5.5" 15.5 ppf BTC to 5.5" 17 ppf BTC with out issues
 
Sort by date Sort by votes
It would be better to move this topic to a neighbouring dedicated forum.
 
Upvote 0 Downvote
You need an OCTG ( oil country tubular goods) end finisher. It likely will fit together.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S
  • Locked
  • Question Question
Use of Nitrogen Purging
Replies
6
Views
4K
Shane33-Simba
S
muariya
  • Locked
  • Question Question
How to calculate tensile capacity of thread or coil tubing tool.
Replies
2
Views
509
muariya
muariya
K
  • Question Question
Impact of 4-Bar Nitrogen Stroke via 30-Inch Line into Low-Level Mogas Tank with IFR
Replies
1
Views
2K
LittleInch
LittleInch
edgardoom
  • Locked
  • Question Question
Ideas of softwares for Oil and Gas industry
Replies
1
Views
1K
1503-44
1503-44
T
  • Locked
  • Question Question
Typical cost for installation of wind girders quotation. Is this reasonable in todays climate?
Replies
1
Views
987
Tom O'Brien
T

Part and Inventory Search

Sponsor

Back
Top