Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

making a hole chart.

  • Thread starter Thread starter froman70302
  • Start date Start date
F

froman70302

Guest
Making a holes chart that is comprised of both sides of an
object (holes made on two faces). I was wondering if there is a way to do this
in WF 5.0?
 
You must log in or register to reply here.

Similar threads

S MORIN
  • Locked
  • Question Question
ptc_material_description in a note
Replies
0
Views
1K
S MORIN
S MORIN
whatev-nvm
  • Locked
  • Question Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
1K
whatev-nvm
whatev-nvm
freerangequark
  • Locked
  • Question Question
Control of a dimension or parameter in simplified rep?
Replies
1
Views
2K
3DDave
3DDave
rc0213
  • Locked
  • Question Question
Making A Door Frame
Replies
4
Views
391
rc0213
rc0213
engineeringspread
  • Locked
  • Question Question
Single Hole Pattern from sketch
Replies
1
Views
728
DesEng1986
DesEng1986

Part and Inventory Search

Sponsor

Back
Top