Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Making a curved helix

Thread starter gwubs
Start date Mar 9, 2009

Status: Not open for further replies.

Mar 9, 2009

gwubs

Industrial

Just reading the thread on making a curved helix, and it reminded me of a Joe Jones XL sheet I have used before. I dug around for it and here it is.
This is not my work, but from Joe's New Hampshire Cad site - (I don't know if his site is still up)
Cheers
Gerald W.