Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Magnetorestrictive Level Measurement

Status
Not open for further replies.
a1987

a1987

Mechanical
Oct 5, 2012
27
Dear Sirs

in a P&ID for a Gear Pump, is present this note "magnetorestrictive Level Measurement"..

The instrumentation should be supplied by pump vendor or this is an instrumentation department problem??
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Depends - is the pump vendor on the hook for the fluid reservoir and its level sensor?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

tonbaldin
  • Locked
  • Question
Help with recirculating pump above tank level 2
2
Replies
28
Views
4K
tonbaldin
tonbaldin
KevinNZ
  • Locked
  • Question
Tank level control, pumps in series
Replies
18
Views
528
1503-44
1503-44
Kannn
  • Locked
  • Question
Determine minumm tank level to prevent pump cavitation 1
Replies
12
Views
506
pierreick
pierreick
Bambie
  • Locked
  • Question
Tandem Reservoir Extension on a Constant Level Oiler?
Replies
8
Views
139
Bambie
Bambie
kbkjnr
  • Locked
  • Question
Define trials and measurements that can be taken for a can type vertical pump
Replies
5
Views
227
Artisi
A

Part and Inventory Search

Sponsor

Back
Top Bottom