Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
<MOD> Paramters
- Thread starter dgiy
- Start date
Hi DG,
these are located in <swinst>\lang\english\gtol.sym (this is language dependant). This is a plain ASCII file which contains several "librarys" (the headings in the dropdownlistbox) and "symbols". Example: the diameter is <MOD-DIAM>, located in the section #MOD in the line *DIAM
HTH,
Stefan
--
unofficial german SolidWorks helppage
Shareware, freeware, tools and macros
these are located in <swinst>\lang\english\gtol.sym (this is language dependant). This is a plain ASCII file which contains several "librarys" (the headings in the dropdownlistbox) and "symbols". Example: the diameter is <MOD-DIAM>, located in the section #MOD in the line *DIAM
HTH,
Stefan
--
unofficial german SolidWorks helppage
Shareware, freeware, tools and macros
BTW, you can edit this file to make some custom symbols. I have a dedicated webpage with some examples at (it's german, but you will understand the examples 
Stefan
--
unofficial german SolidWorks helppage
Shareware, freeware, tools and macros
Stefan
--
unofficial german SolidWorks helppage
Shareware, freeware, tools and macros
- Status