Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

LPG ODORANT INJECTION SYSTEM

Status
Not open for further replies.

Regi1989

Mechanical
Joined
Sep 30, 2015
Messages
11
Location
PH
Hello everyone! I am designing an LPG Odorant Injection System using mercaptan as the odorant. This is my first time to design such system. I only have the required odorant concentration which is 22.5ppm. How can i determine the required odorant gas flow and injection pressure? Thanks a lot.
 
ppm is on a mass basis, so 22.5 ppm is just saying for every 1,000,000 total lbs/hr (or kg, etc.) 22.5 must be mercaptan and the remainder of 999977.5 must be LPG. You will need to measure the flow of LPG and meter in the odorant based on a ratio. Injection pressure needs to be higher than the LPG line. I have never worked on this specific application, but I'm thinking a sparger of some kind may be useful in mixing the odorant in to the LPG stream.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top