Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Looking for ISO 500 PTO shaft teeth diagrams

Status
Not open for further replies.

AussieDaz

Specifier/Regulator
Nov 6, 2020
1
Hi all,
Im looking to make a new coupling for the farm industry or any industry that uses PTO.
Im looking at the 6 tooth 1 3/8", 20 tooth 1 3/8" & 1 3/4" and 21 tooth 1 3/8" & 1 3/4"
The input hub needs to be machined with the above specs.
I have looked around, the ISO500 has the general specs but not the Actual dimensions
Can anyone point me to or attach the document with the above specs to machine to fit these PTO splines
Thank you
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor