Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Lineweight positioning
- Thread starter taffcad
- Start date
- Thread starter
- #3
Hi
Thanks for the reply.
The person told me its similar to using Multiline where you can set the position for the offset line to be either centre/top/bottom alignment. With the lineweight button selected highlighted then the preview lines are shown above/below or centred. I think the idea is so that close adjacent lines can still be shown? It maybe in the print options somewhere. Will check it out and post if I find it.
Thanks for the reply.
The person told me its similar to using Multiline where you can set the position for the offset line to be either centre/top/bottom alignment. With the lineweight button selected highlighted then the preview lines are shown above/below or centred. I think the idea is so that close adjacent lines can still be shown? It maybe in the print options somewhere. Will check it out and post if I find it.
Could this be what you are talking about?
"Everybody is ignorant, only on different subjects." — Will Rogers
"Everybody is ignorant, only on different subjects." — Will Rogers
- Status
Similar threads
- Locked
- Question