Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

liner for sulfur gas blower

Status
Not open for further replies.

jamer

Structural
Mar 8, 2005
2
First, thanks in advance for any help you can provide.

I am building a blower housing which will be handling sulfur gas. The shaft for the fan is water sealed so there is potential for mild sulfuric acid.

The unit I am replacing seems to have a rubber liner. Is this the best material to line the unit with?

If it is then where can I get a liquid rubber product that I can paint or spray on myself?

Housing and all parts are stainless steel.
 
Replies continue below

Recommended for you

Am I posting this in the right area?

I didn't think i needed to reinvent the wheel on this, seems like it would be a pretty common setup. Should this be in the chemical plant forum?

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor