Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
LENGTH RATIO in distortion control
- Thread starter liq001
- Start date
The meaning of this parameter is explained in the documentation chapter "Section controls --> Controlling element distortion for crushable materials in Abaqus/Explicit --> Controlling the distortion length ratio". I wouldn't change it from the default value without a good reason.
- Status
Similar threads
- Question
- Locked
- Question