Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Leaking weldments 1

Status
Not open for further replies.
bscfrnd2

bscfrnd2

Mechanical
Dec 1, 2011
1
we are working on reduction gear boxes and on 1 of them we have small pin hole leaks near heat sink gussets . I was wondering if anyone had ever tried used a slight vacuum to draw a sealant into a defective pin holed weld or crack . If so what type of sealant did you use. These places are difficult to get into to repair and time is a issue.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom