labview project 2011

[johneedw]

Hello,
I've a lab view project working under lab view 2011. the license of the lab view software has expired then i've downloaded a trial lab view 2001 version from web and it has installed successfully but the project stop to work !.Also, the ladder diagram of the project can't be browsed !.
by the way, during installation of lab view, the attached message is appear and i've no idea about !, hence, i choose (decline support) to complete installation.
Please advice me about this message and if this might cause the problem ?!..

 

[IRstuff]

Well, the message says that you need to re-install any drivers you might need.

TTFN
faq731-376
Need help writing a question or understanding a reply? forum1529


Of course I can. I can do anything. I can do absolutely anything. I'm an expert!
There is a homework forum hosted by engineering.com:

http://www.engineering.com/AskForum/aff/32.aspx

 

[johneedw]

Thank you for kind reply, but i've installed all the related drivers !.
Don't you think that the trial version might not support full function?
.

 

[MacGyverS2000]

If you had a working version and are not actually trialing the software, why are you trying to use a trial version? Mixing versions (especially one so old... 2001?) is never a good idea, particularly when it comes to hardware device drivers.

Have IT update your license and be done with it.

Dan - Owner

http://www.Hi-TecDesigns.com

 

[zappedagain]

Was 2001 a typo? Did you install the 2011 trial version? A design in 2011 is going to need drivers from the 2011 install, so I agree with Dan.

You might find some other options in Forum244 (National Instruments:LabVIEW).

Z

 

[IRstuff]

You probably meant: forum1106

TTFN
faq731-376
Need help writing a question or understanding a reply? forum1529


Of course I can. I can do anything. I can do absolutely anything. I'm an expert!
There is a homework forum hosted by engineering.com:

http://www.engineering.com/AskForum/aff/32.aspx

 

[zappedagain]

Yes I did. Thanks!

Z