Tobin1
Petroleum
- Nov 9, 2007
- 176
Howdy All,
Attached is a revised copy of a Label View macro for SolidWorks.
It can be used to add a SW Note type Label to a Drawing View. The View Label can include the correct scale. Many other improvements have been added to this revision. I'm sure you'll like them.
Included are Icon.bmps for the toolbar and instructions on how to add it.
This can also be found at I would appreciate any comments you may have after looking this over.
Thanks to all of you who answered my questions and put up with me
Tobin Sparks
Attached is a revised copy of a Label View macro for SolidWorks.
It can be used to add a SW Note type Label to a Drawing View. The View Label can include the correct scale. Many other improvements have been added to this revision. I'm sure you'll like them.
Included are Icon.bmps for the toolbar and instructions on how to add it.
This can also be found at I would appreciate any comments you may have after looking this over.
Thanks to all of you who answered my questions and put up with me
Tobin Sparks