Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Label and 3D centreline Automation problem NX 8.5

Thread starter vikrass
Start date Feb 17, 2016

Status: Not open for further replies.

Feb 17, 2016

vikrass

Mechanical

Hi,
3d Centrelines and Labels are not maintaining their positions when the model configuration is changed from larger to the smallest. Leaders of the labels going elsewhere and Associativities of The same are retained though. (View scales are automated.)

Vikrant