Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

krauss maffei mc3 controller porblem

Status
Not open for further replies.
ravjeet

ravjeet

Electrical
Joined
Nov 10, 2002
Messages
1
Location
IN
hi,
i am facing a picular problem with my krauss maffei injection moulding m/c 60-210 with mc3 controller .when power is switched on the system test screen comes and stays on .there is no change by pressing any key on the key board also .i have changed the mc300 card also but no change.
 
Status
Not open for further replies.

Similar threads

DrDrreeeaaa
  • Locked
  • Question Question
Burst Firing for an AC Voltage Controller - What is the supply current rating?
Replies
8
Views
785
waross
waross
jmbelectrical
  • Locked
  • Question Question
Elevator Controller SCCRs
Replies
4
Views
869
jraef
jraef
mingki
  • Locked
  • Question Question
How to protect a motor controller from the noise coming out of relay
Replies
1
Views
243
itsmoked
itsmoked
shmglob
  • Locked
  • Question Question
Controller installed on the enclosure floor.
Replies
9
Views
334
itsmoked
itsmoked
Indy
  • Locked
  • Question Question
Compressor Anti-Surge controller
Replies
1
Views
178
crshears
crshears

Part and Inventory Search

Sponsor

Back
Top