Aug 3, 2007 #1 tominsky67 Mechanical Jan 16, 2007 36 Is there a quick & easy way to create a knurl patern on a cylinder?... such as this... (see 4th image) http://www.scottjbaugh.com/Design_Portfolio/Contributed SW models.htm SE V15
Is there a quick & easy way to create a knurl patern on a cylinder?... such as this... (see 4th image) http://www.scottjbaugh.com/Design_Portfolio/Contributed SW models.htm SE V15
Aug 3, 2007 #2 KENAT Mechanical Jun 12, 2006 18,387 I've done similar (not as nice) using different cuts/swept cuts etc but... From a memory/processor point of view unless you really need it I'd advise against it. KENAT, probably the least qualified checker you'll ever meet... Upvote 0 Downvote
I've done similar (not as nice) using different cuts/swept cuts etc but... From a memory/processor point of view unless you really need it I'd advise against it. KENAT, probably the least qualified checker you'll ever meet...
