Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

keeping tabs open

  • Thread starter Thread starter D. Urban
  • Start date Start date
D

D. Urban

Guest
Hi,<?:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" />
I have just jumped into Creo from wildfire 4, my first problem is figuring out how to keep tabs from closing down after selecting an item. Example: in sketcher tab, select line and the tab shuts automatically? I have to re-open the sketcher tab to select anything else. This applies to all tabs however from the demos that I have seen I know this is not standard practice.
Could somebody please direct me to the setting to keep them open?

Thanks:
 
Found it!


Thanks anyway.
 
oh...good!! Was it perhaps that you rightclicknext tothe ribbon and unchecked "minimize the ribbon"? If so, please state that it works in the version of creo you are using, thats in case of some other users of this forum wonder the same thing! If not , please tell us what your solution is.


//Tobias
 
How did you solve it?????
 
Found it! Just a frustrated Cero newbie that couldn
 

Part and Inventory Search

Sponsor

Back
Top