Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ISO vs ANSI Flanges
- Thread starter SPLIT
- Start date
No but you can ask the manufactor to drill holes in an ISO flange to ANSI standard (or the other way). But note that the ISO flange is thinner (for identical pressure classes / ND) and that additional stress calculations may be required.
Best regards
Morten
Best regards
Morten
- Status
Similar threads
- Question
- Question
- Locked
- Question
