Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Involute Spine

Status
Not open for further replies.
ubetcha

ubetcha

Mechanical
Feb 8, 2012
3
I'm trying to change to an involute flat root side fit spline on a shaft design. ANSI B92.1-1970, is the standard referenced in machinery's handbook. The shaft OD is 1.187". Can anyone with the standard help me out with the dimensions of the shaft and coupling?
 
Status
Not open for further replies.

Similar threads

mbl1980
  • Locked
  • Question
Unknown involute spline
Replies
8
Views
372
mfgenggear
mfgenggear
mojo41
  • Locked
  • Question
Worn Involute Spline? 3
Replies
8
Views
448
CouplingGuru
CouplingGuru
vadacz
  • Locked
  • Question
I need HELP! with a DIN 5480 involute spline
Replies
1
Views
101
tbuelna
tbuelna
jagodragon
  • Locked
  • Question
Involute Knurling, No base diameter supplied??? 2
Replies
9
Views
180
tbuelna
tbuelna
ALREMAN
  • Locked
  • Question
Involute Spline Alignment
Replies
3
Views
197
ALREMAN
ALREMAN

Part and Inventory Search

Sponsor

Back
Top Bottom