Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
inventor hardware
- Thread starter DenisVan
- Start date
Did you install the standard content libraries when you installed the software? If not put the disc back in and choose to install the libraries you think you will use.
If you have but they are not available you may have to add the libraries to your project file. Select the button just up to the right of the done button in the projects window. It is called Configure Content Centre Libraries.
If you are having trouble placing parts, then select the drop down next to place component and select place from content centre. Also check out the design accelerators under the design tab.
If you have but they are not available you may have to add the libraries to your project file. Select the button just up to the right of the done button in the projects window. It is called Configure Content Centre Libraries.
If you are having trouble placing parts, then select the drop down next to place component and select place from content centre. Also check out the design accelerators under the design tab.
- Status
Similar threads
- Locked
- Question