Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inventor draft 1

Status
Not open for further replies.
Your attachment didn't work.. try again
 
Dear Sir,
Thank you for your promp reply...
[bigsmile]
It's OK to do with taking parallel plane to upper most point.
But for manufacturing point of view, we need provide drill bit length. In that case how to use this feature, let me know.[dazed]
 
Drill bit length from what???? what point? where to where?

Create your plane at whatever height they are going to touch the tools off at (but its going to be the upper most point assuming they are starting with a block of material and not a part with the inclined plane already there.. or whatever you consider the 0 point in the Z axis
Surely they aren't going to touch off tools on an angled surface.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top