Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inventor 9 Sheet metal

Status
Not open for further replies.
cadmate

cadmate

Mechanical
Joined
May 5, 2005
Messages
84
Location
GB
Is it possiable in sheet metal ipt, to create a linear fold ie radius at one end say 44mm and other end say 2mm
if so how? (in MDT 2005 its quite simple to create a linear fillet where R1=X & R2=2X)
 
Status
Not open for further replies.

Similar threads

CAD2015
  • Question Question
Inventor 2026 ...................
Replies
2
Views
13K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
TABLE move in Inventor.......
Replies
1
Views
1K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
Inventor vs Fusion: Similarities & Differences.........................
Replies
2
Views
2K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
Learning Inventor Nastran...................
Replies
11
Views
2K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
Inventor/Fusion 360 Wiring Harness Design
Replies
2
Views
1K
CAD2015
CAD2015

Part and Inventory Search

Sponsor

Back
Top