Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Inventor 2009 and ANSYS Workbench 11.0

Status
Not open for further replies.
ansysfreak

ansysfreak

Civil/Environmental
Joined
Feb 27, 2005
Messages
167
Location
NL
Dear All

Are there Interface problems using Inventor 2009 and Workbench 11.0 sp1?
This is officially not supported by ANSYS but usely it still works. The 32-bit version of Inventor with 32-bit Workbench still works, but when Inventor becomes 64-bit the interface is killed.
Who is facing the same problem(s)?
Are there know workarounds?

Thanks
Garry
 
Status
Not open for further replies.

Similar threads

CAD2015
  • Question Question
Inventor 2026 ...................
Replies
2
Views
13K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
TABLE move in Inventor.......
Replies
1
Views
1K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
Inventor vs Fusion: Similarities & Differences.........................
Replies
2
Views
2K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
Learning Inventor Nastran...................
Replies
11
Views
2K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
Inventor/Fusion 360 Wiring Harness Design
Replies
2
Views
1K
CAD2015
CAD2015

Part and Inventory Search

Sponsor

Back
Top