M
malex75
Guest
Hello to everybody.
I am a mech Engineer. I work in Italy in a mech factory.
I use Pro-E since 2001 but I am new in Pro/mechanism.
I have this simple question. I have an assembly with two parts. There is interference between the two parts; each part rotate around its axis.
Is it possible to make a boolean operation during the rotation?
In other words remove the interference in one of the two parts.
I am looking for this topic in the forum but I didn't find anything.
Thanks in advance
I am a mech Engineer. I work in Italy in a mech factory.
I use Pro-E since 2001 but I am new in Pro/mechanism.
I have this simple question. I have an assembly with two parts. There is interference between the two parts; each part rotate around its axis.
Is it possible to make a boolean operation during the rotation?
In other words remove the interference in one of the two parts.
I am looking for this topic in the forum but I didn't find anything.
Thanks in advance
