Guest
(using the assembly constraints)How do you insert a shaft in another shaft that has a hole running perpendicular to the axis? When you put a hole in the second shaft perpendicular to the axis it is not recognized as a hole.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Dear Logos;
There are many ways to do this.
Constrain pin line/line with the perpendicular hole
Constrain the end of the pin line/plane with the centerline/axis of the shaft and enter a distance that puts the pin in as far as you require it.
I use this for inserting cotter pins in shafts for example
Regards Adrian
There are many ways to do this.
Constrain pin line/line with the perpendicular hole
Constrain the end of the pin line/plane with the centerline/axis of the shaft and enter a distance that puts the pin in as far as you require it.
I use this for inserting cotter pins in shafts for example
Regards Adrian
- Status
Similar threads
