I have an electric motor turning 1775 rpm, driving a speed/torque reducer with a 37.5-1 ratio. There is an 8 inch pulley on the output shaft which steps up to a 12 inch pulley on my conveyor headspool. What are the rpms on my 12 inch sheave and what is the rule of thumb to figure this out next time? thank you
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
input/output rpm ratio
- Thread starter crosstown
- Start date
- Status
Similar threads
- Locked
- Question