Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

impose shrinkage strain on shellelements

  • Thread starter Thread starter -
  • Start date Start date
Status
Not open for further replies.

Guest
hello,
how can i impose a shrinkage strain on a small area (patch) of a cylinder? With a plane plate i can ude the displacement of boundary conditions, but using curved shells i get problems imposing displacements (because i want to impose strains).
thanks for any help/advice
anton
 
Status
Not open for further replies.

Similar threads

BigMims
  • Locked
  • Question Question
Strain field smoothing
Replies
2
Views
397
BigMims
BigMims
C
  • Locked
  • Question Question
Generalised plane strain using Abaqus Explicit
Replies
1
Views
1K
FEA way
FEA way
Bishal123
  • Locked
  • Question Question
ABAQUS shear strain rate
Replies
1
Views
470
FEA way
FEA way
R
  • Question Question
Zig-Zag Strain Pattern in NSM FRP Pull-Out Simulation (Cohesive Zone Model) – Need Help
Replies
2
Views
9K
Roshaan
R
S
  • Question Question
TO FIND CONCRETE DAMAGE PLASTICITY MATERIAL PROPERTIES FOR STEEL FIBRE REINFORCED CONCRETE BY USING EXPERIMENTAL STRESS STRAIN RESULTS
Replies
0
Views
3K
Shreyas M
S

Part and Inventory Search

Sponsor

Back
Top