Hello!
1 I am trying to import ecad (idf 3.0(emn,emp)) from Cadence Allegro to ProE Wildfire 2.0 and I do get the blocky boxes as components, but somehow I always end up with inches as units. Both Allegro and ProE is set on mm. Is there anything that I could have missed (probably..)?
2 I am also looking for any kind of library of pre made electrical parts such as resistors, caps, connectors, IC's etc. Any ideas? I know there is a website selling a package, anyone tried that? Dont know if I am allowed to write the address so I block some letters out
This is my first post on my first job so be kind
1 I am trying to import ecad (idf 3.0(emn,emp)) from Cadence Allegro to ProE Wildfire 2.0 and I do get the blocky boxes as components, but somehow I always end up with inches as units. Both Allegro and ProE is set on mm. Is there anything that I could have missed (probably..)?
2 I am also looking for any kind of library of pre made electrical parts such as resistors, caps, connectors, IC's etc. Any ideas? I know there is a website selling a package, anyone tried that? Dont know if I am allowed to write the address so I block some letters out
This is my first post on my first job so be kind
