Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Idle air valve for ITBs

Status
Not open for further replies.

CleverHans

Automotive
Joined
Feb 15, 2004
Messages
9
Location
AU
I am looking to fit ITBs to a 4 cylinder using the proprietary bodies that bolt to DCOE manifold. Because of a 'adventurous' camshaft (Schrick 316 deg) I am looking use a combination of TPS and MAP and to improve drivability I am considerng using a GM IAC valve. I am using Kalmaker/Delco.

I am planning to drill holes in each of the manifold runners down stream of the take off for the MAP sensor and plumb them to the IAC valve. This would minimise interference for the MAP as much as possible.

Comments on this are welcomed.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top