G
Goby
Guest
Hi, I'm new to this forum so I hope this topic is in the right place.
In one of my assemblies I'm using connections to assemble the covers of the machine so that I can open themlike doorsandtry to take snapshots of the differentpositions of the doors to show this in a drawing (asolution I found onone of the forums here
). The problem is that whatever I do, all the snapshots are identical to the last snapshot.
I tried it some other assemblies and there it works just fine. Already had a couple of my more experienced collegues give it a try but they wonder just like me what is going on. Does anybody have an idea what is going on??
In one of my assemblies I'm using connections to assemble the covers of the machine so that I can open themlike doorsandtry to take snapshots of the differentpositions of the doors to show this in a drawing (asolution I found onone of the forums here
I tried it some other assemblies and there it works just fine. Already had a couple of my more experienced collegues give it a try but they wonder just like me what is going on. Does anybody have an idea what is going on??
