Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Ideas 11m3 - Memory settings
- Thread starter Freemesh
- Start date
The rule of thumb is to use a Total Virtual Memory Limit which is about 95% of the physical RAM on your machine.
With regards to the ratios/percentages, for "normal use" I'd return these to how they were before you modified the Virtual Memory Limit.
Use this as a starting point and then address any memory related errors, should they arise, by adjusting the percentages. Always make sure that the percentages add up to 100% at the bottom though.
With regards to the ratios/percentages, for "normal use" I'd return these to how they were before you modified the Virtual Memory Limit.
Use this as a starting point and then address any memory related errors, should they arise, by adjusting the percentages. Always make sure that the percentages add up to 100% at the bottom though.
To use manual memory tuning, automated memory tuning has to be turned off by
setting the Memory.AutoSetting to 0 in the global I-DEAS parameter file. The
DEFAULT location for this file is:
unix: $SDRC_INSTL/ideas/.ideas_paramX
NT4/Windows 2000: DRIVE:\team\master\config\ideas_paramX.dat
where X is the version of I-DEAS and DRIVE is the drive letter where
team is located.
setting the Memory.AutoSetting to 0 in the global I-DEAS parameter file. The
DEFAULT location for this file is:
unix: $SDRC_INSTL/ideas/.ideas_paramX
NT4/Windows 2000: DRIVE:\team\master\config\ideas_paramX.dat
where X is the version of I-DEAS and DRIVE is the drive letter where
team is located.
- Status
Similar threads
- Locked
- Question