Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I was wondering if anyone could pos

Thread starter Tmoore
Start date Sep 17, 2003

Status: Not open for further replies.

Sep 17, 2003

Tmoore

Mechanical

I was wondering if anyone could possible suggest a good supplier in the area of toronto/kitchener/waterloo region who could make a 16 mirror finish on several parts I am designing. Also I was wondering if anyone knows a way I could manufacture a part with this surface finish myself, and suggest some tools I could purchase to do this. The two parts I am speaking of are the following: 1) a 17.500" diameter plate - SS 304. 2) A part that is basically in the shape of a tube, it has a 17.500" ID and a 20.000" OD, and this part has a piped shape protrusion coming out the side of it about 5" long. Any suggestions would be greatly appreciated.
Cheers,
Tom