Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I want to know the best design met

Status
Not open for further replies.
lumban

lumban

Chemical
Joined
Oct 28, 2003
Messages
1
Location
ID
I want to know the best design method for extruder and pelletizer, the flow rate is about 10,000 tonnes/hour, the exit pellet is approximately 2.5 mm. Extruder feed is bioplastic polymer. thank u and my best regards for eng-tips.com

regards


lumban
 
Status
Not open for further replies.

Similar threads

Alinpsh
  • Locked
  • Question Question
Hello, good time I want to convert
Replies
3
Views
894
pierreick
pierreick
MSL93
  • Question Question
Design Pressure due to Deflagration
Replies
5
Views
5K
seuenergy
seuenergy
R
  • Question Question
Vapor recovery unit (VRU) design and methodology
Replies
4
Views
20K
georgeverghese
georgeverghese
S
  • Question Question
spill collection underground tank design
Replies
1
Views
4K
LittleInch
LittleInch
A
  • Question Question
ASME Sec I, PTFH 12.2- Liquid Thermal Fluid Heater
Replies
0
Views
2K
Ash-
A

Part and Inventory Search

Sponsor

Back
Top