I want to draw some curve on cylinder in nx 10

[Hitesh7709]

Hey All. i m using nx 10. i need your help guys as m stuck in a situation where i wan to draw some shapes on a cylindrical surface. i tried project curve wrap unwrap surfaces an all but couldnt get the desired output. i know the angle between the curves but dont know to to actally draw that or take that angle an draw on that..what could be the procedure to draw on cylindrical surfaces . Thank you waiting for your reply guys

 

[Toost]

Wrap curve is the feature if you want to wrap a planar profile on a cylindrical face.
start the wrap curve command, then press F1 for context sensitive help.

Regards,
Tomas