Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to use inistate command

Status
Not open for further replies.
aboozarmd

aboozarmd

Structural
Joined
Jan 7, 2016
Messages
3
Location
IN
I would like to input my strain data in the ansys model and see the bending movement and the behavior of the model. i have tried by using inistate command but there is no effect on the model after inputing the data so please let me know to input the strain data to the model
Thank you
 
Status
Not open for further replies.

Similar threads

EdwardNigma
  • Question Question
What boundary condition techniques do you use to keep FEA models realistic?
Replies
8
Views
21K
GregLocock
GregLocock
F
  • Question Question
How to determine G12 if I have E1, E2 and v12?
Replies
4
Views
5K
rb1957
rb1957
Kamyar_K
  • Question Question
How to get uniform tension in a rail using dynamic/explicit analysis?
Replies
6
Views
9K
rb1957
rb1957
D
  • Locked
How to take pickup support
Replies
0
Views
3K
deepak1313
D
EdwardNigma
  • Locked
  • Question Question
Mastering FEA: How to Get Through Stage 2 (Developing Good Modeling Techniques)?
Replies
7
Views
4K
rb1957
rb1957

Part and Inventory Search

Sponsor

Back
Top