I am a beginner with ProE and have not yet successfully found any guide on how to taper a curved section as shown in the attached sketch. I believe the "extrude" function has an option to flare/taper the geometry, but I have not figured out how to apply that to a curved trajectory. The section is an "open" circle with a "neck" for water to travel between the impeller and casing.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to taper curved section? 1
- Thread starter KimWonGun
- Start date
-
1
- #2
I would make that part with a rotational blend. You would draw a new section at each place the section changes and do a straight blend between them.
----------------------------------------
The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
----------------------------------------
The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
ProEDesigner00
Mechanical
you could accomplish this using a swept blend
Norbert
Norbert
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Solved
- Question