Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to split a "ring"? 1

Status
Not open for further replies.

CNSZU

Mechanical
Joined
Sep 2, 2005
Messages
318
Location
TW
Hello,

Is it possible to split a ring (extruded solid with a thickness) into two solids? See attached image where the split is supposed to be. The Split Body tool gives the message "The tool and target do not form a complete intersection". Any ideas about the "proper way" to accomplish this task?

PS: the split tool works if the two lines intersect the center of the ring, however in this case the lines are supposed to be parallel.

NX8.5 Win7SP1 64bit i7-3770K@4.3Ghz 16GB Quadro2000
 
That works brilliantly, thank you!

NX8.5 Win7SP1 64bit i7-3770K@4.3Ghz 16GB Quadro2000
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top