Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to model a persian or arabic Tar (Musical Instrument) in solidworks

  • Thread starter Thread starter bijankaraji
  • Start date Start date
B

bijankaraji

Guest
I am having very hard time modeling this tar, any help on it is greatly appreciated.
attached are the pictures of this Tar.
Length is about 30 Cm
Width is about 25 at the back end and about 15 at front end
The Height is about 18 Cm
Regards
bijankarajiView attachment 1849View attachment 1850View attachment 1851
 

Attachments

  • 5.jpg
    5.jpg
    52.6 KB · Views: 0
  • 4.jpg
    4.jpg
    51.7 KB · Views: 0
  • 3.jpg
    3.jpg
    55.2 KB · Views: 0
Last edited:
You must log in or register to reply here.

Similar threads

V
Problem to open a .obj file with the textures visible on the model in Solidworks 2022
Replies
0
Views
63
victor andreevich
V
jassco
  • Locked
  • Question Question
Solidworks VBA to GET and SET dimensions on a sketch in an assembly model
Replies
1
Views
2K
jassco
jassco
CAD2015
  • Locked
  • Question Question
SolidWorks vs 3DEXPERIENCE SolidWorks
Replies
4
Views
3K
CAD2015
CAD2015
K
  • Question Question
Solidworks Assembly - Using Mass Properties of part instance to control dimensions of parts in assembly
Replies
3
Views
3K
jassco
jassco
CAD2015
  • Locked
  • Question Question
How to count the components in a SolidWorks assembly?
Replies
8
Views
2K
CAD2015
CAD2015

Part and Inventory Search

Sponsor

Back
Top