Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to match the mesh of new volume/area to existing mesh

Thread starter flyingcow1999a
Start date Mar 8, 2012

Status: Not open for further replies.

Mar 8, 2012

flyingcow1999a

Structural

How to match the mesh of new volume/area to existing mesh

Hi, I have a meshed model with nodes and elements and the geometry info for volume and area are lost. Now I need to add some volume and area to the existing model. Is there any way I can make the added volume and area aumomtically meshed based on the sharing area/line for the volume and area addition?

Thanks...