Looks like I am covering some new ground at work with ellispes, but... how does a person contrain an ellipse created in a sketch in NX9? Is it something that can be constrained? If not, I ask those in the audience that used Check-Mate or manually check for a fully contrained sketch deal if it is something that cannot be constrained?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to Constrain an Ellipse in a Sketch in NX9?
- Thread starter MASawtell
- Start date
- Thread starter
- #2
You are in luck, there is a "how to" in the NX help file on just that topic.
CAD -> Sketching -> creating sketch curves -> ellipse -> fully constrain an ellipse
www.nxjournaling.com
CAD -> Sketching -> creating sketch curves -> ellipse -> fully constrain an ellipse
www.nxjournaling.com
- Status
Similar threads
- Locked
- Question