How to change dimension associativity 1

[PSI-CAD]

Hi,

It's a very basic question in drafting (NX7.5) but I can't remember

How to break the link between dimension in Chain dimension ?

Thanks in advance

Regards
Didier Psaltopoulos

http://www.psi-cad.com

 

[jerry1423]

rmc (right mouse click) on the extention line that you want to reaasociate
then edit associativity

 

[PSI-CAD]

Hi Jerry,

I was not clear in the tittle. It's not the associativity but the position

Regards
Didier Psaltopoulos

http://www.psi-cad.com

 

[JohnRBaker]

OK, double-click the dimension of interest (so that you're in the edit mode), press MB3, select the 'Offset' option and type in how far you wish to move it ('+' for up, '-' for down). Note that if you're moving a dimension in the middle of the 'Chain' that you will probably need to move all the dimensions to the right or left of this one the same amount in the opposite direction.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.