Hello, my problem is how to apply the degrees of freedom on both ends of an aircraft fuselage in Ansys Workbench. I want to keep the same hoop stress over the entire surface of the fuselage (especially in the middle of the fuselage). I only apply the internal pressure in the fuselage as a first step, after, I will apply the bending moment. thank you for your support
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
how to apply the DOF in Ansys Workbench?
- Thread starter mazziyad
- Start date
Similar threads
- Locked
- Question
- Question
- Locked
- Question
- Locked
- Question