Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to add composite layers of 90,0,90,0 degree to a shell of thickness 1mm in LS-Dyna?

Thread starter Mohammed Siddique Ahmed
Start date Oct 5, 2016

Status: Not open for further replies.

Oct 5, 2016

Mohammed Siddique Ahmed

Automotive

Dear Friends,

I am modelling a Composite layered model with Mat_54/55 in LS-Dyna. I am able to layup the plies in Part_composite but 1) how to attached this stackup to my 1 mm shell plate?.

How to add composite layers to a shell of thickness 1mm in LS-Dyna? - ResearchGate. Available from:

https://www.researchgate.net/post/H..._1mm_in_LS-Dyna#view=57f4c2cacbd5c218cb72bea5

[accessed Oct 5, 2016].