buddhikasriw
Mechanical
Hi I,m having difficulty/stuck in stetting up the parameter for Thread Turning in Creo 3 Manufacturing.
My thread size and detail are as follows,
3/4 - 10 UNC Thread ( 10-TPI)
Maj. Dia - 0.733"
Min. Dia - 0.625"
Thread Length - 3.7"
Is my attached image value correct?
Please some one clarify what is this CUT_FEED, THREAD_FEED, PERCENT_DEPTH
Thank you,
Buddhika
Mechanical Engineer
My thread size and detail are as follows,
3/4 - 10 UNC Thread ( 10-TPI)
Maj. Dia - 0.733"
Min. Dia - 0.625"
Thread Length - 3.7"
Is my attached image value correct?
Please some one clarify what is this CUT_FEED, THREAD_FEED, PERCENT_DEPTH
Thank you,
Buddhika
Mechanical Engineer