Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I create macros?

  • Thread starter Thread starter gshock
  • Start date Start date
G

gshock

Guest
Hi All,
I'm new to UG, but I've used SolidWorks and ProE before. Enough to say so, but not enough to be an expert. I'm proficient.

How do I create macros in UG? I don't even know where to start. What I'm trying to do is gather some basic measurements in the X-direction.

Thanks in advance,

-gshock
 
You must log in or register to reply here.

Similar threads

Jashe
  • Question Question
How to create Radial Section Cut on NX Drawing
Replies
5
Views
11K
SDETERS
SDETERS
O
  • Locked
  • Question Question
NX journaling/macros "session state" and conditional programming
Replies
0
Views
1K
Oliver B
O
rothers
  • Question Question
I-Deas .xpk
Replies
7
Views
16K
rothers
rothers
CAD2015
  • Locked
  • Question Question
Curves do not show in Assembly.
Replies
4
Views
2K
CAD2015
CAD2015
CAD2015
  • Locked
  • Question Question
Create Sheet and Drawing templates........................
Replies
7
Views
4K
CAD2015
CAD2015

Part and Inventory Search

Sponsor

Back
Top